两人做人爱费视频免费完整版

  • <code id="yybq7"></code>
  • <big id="yybq7"></big>
    <th id="yybq7"><option id="yybq7"></option></th>

    <del id="yybq7"><small id="yybq7"></small></del>
    1. <tr id="yybq7"><option id="yybq7"><acronym id="yybq7"></acronym></option></tr><code id="yybq7"><em id="yybq7"></em></code>
      <thead id="yybq7"><option id="yybq7"></option></thead>
    2. <code id="yybq7"><small id="yybq7"></small></code>
    3. 中文 | ENGLISH

      Question&Answer

      8. What kind of problem may meet when using professional scrubber.

      時間:2018-03-30 13:24:45 作者:admin 點擊次數:

      The problems in use can be solved easily if the machine selected is matching with the floor condition, however, most of the problems happened because the machine selected is not matching with the floor condition, but not cause by the technology or the machine itself. 
      Bellowing are the possible problem about the safety and cleaning effect:
      operative problem
      water yield of brusher is not enough
      1)     Check if the flashing valve opened, check both hand valve and electromagnetic valve.
      2)     Check if there is water in the solution tank.
      3)     Check the filter, if any.
      4)     Check if hosepipe connecting with the brusher is jam.
      cleaning effect is not good
      1)  checking the attrition rate of the brusher, and change the brusher if necessary. ( if the bristle is crimp over than 15mm it need change the brusher right now)
      2)  changing the type of brusher, it is very important that use the suitable brusher for different floor.
      intake system can not take way the waste water completely.
      1)     Check if there is filth inside the rubber blades.
      2)     Replace the rubber blade or adjust its angle to get better effect, the rubber blade should be slant backward 5mm during working, the whole length should be in this way.
      3)     Check if the hosepipe is well connected with the recovery tank.
      4)     Take down and clean the water intake system.
      5)     Change the rubber blades.
      6)     Check if the switch for the water pump is on or off.
      7)     Adjust the runner of water pump
      too much foam
      Check if solution is low foaming, or add antifoams into the recovery tank.
      Pls note the floor more clean the foam is more, so dilute solution should be used in this situation. 
      两人做人爱费视频免费完整版

    4. <code id="yybq7"></code>
    5. <big id="yybq7"></big>
      <th id="yybq7"><option id="yybq7"></option></th>

      <del id="yybq7"><small id="yybq7"></small></del>
      1. <tr id="yybq7"><option id="yybq7"><acronym id="yybq7"></acronym></option></tr><code id="yybq7"><em id="yybq7"></em></code>
        <thead id="yybq7"><option id="yybq7"></option></thead>
      2. <code id="yybq7"><small id="yybq7"></small></code>